Fly Away Simulation
SearchSearch 

Saitek Yoke Programming Frustration

Pro Member Trainee
mickwill Trainee

Hi All,

I'm trying to get the Throttle Quadrant to do what I want it to do. These are the three levers labled Z axis (Black), Rx (Blue) and Ry (Red).

I want to assign Flap setting to Z, Left engine to Rx and Right engine to Ry. Should be easy huh? Moving Rx & Ry past the dentat should active the reverse thrust (Buttons 22 & 23).

After two hours I cannot get it to work properly.

Has anyone done this or am I missing the commands or am I not putting in the right commands.

Best Regards

Mick

Pro Member Chief Captain
RadarMan Chief Captain

Try downloading and using the SST.

http://www.saitek.com/UK/down/drivers.php

Radar

Pro Member Trainee
mickwill Trainee

Hi RM,

Yes I have SST but when I put in the K/B commands it's like the axis act differently to each other. Also when I reasign the Z (Black) Axis both the flaps AND throttle advance.

Best Regards

Mick

Pro Member Chief Captain
RadarMan Chief Captain

You should be able to get help here.

http://www.saitekforum.com/

Radar

All times are GMT Page 1 of 1 You can post new topics in this forum
You can reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Related Topics